When the software has finished loading into the FXM, the pop-
up shows “Loaded OK in (xx) seconds.” If an error message
appears, turn off the FXM and start over again.
Firmware is loaded.
Note:
It should not take more than one or two restarts to load the software.
If problem persists, contact Alpha Technical Support.
Type (all lower case) 8. exit and press ENTER. The uBug12
screen disappears.
Turn the battery breaker off.9.
To check if the installation was successful, turn the battery 10.
breaker back on and the LCD’s logo screen should appear as
follows. If it shows “Alpha XP ISP” as shown in step 3 earlier. Try
installing the firmware again.
Alpha
FXM
120/60/N
LINE
81
Maintenance
Doc# 017-201-B0 Rev 0408
Comments to this Manuals