Alpha XM 6015 Series Operations Instructions download pdf (Page 20)

2. FRONT PANEL

2.5 Standby Data Display (SDD)

The optional, dual-function LED "STANDBY DATA" display is used to keep track of

accumulated inverter run time, and to record the number of standby events that have

occurred. The "ELAPSED TIME" clock is activated only when the power supply is in

inverter mode. Elapsed time will continue to accumulate until the clock is reset. The

"STANDBY EVENTS" counter displays the number of standby events that have lasted

longer than 60 seconds duration. Standby events will continue to accumulate until the

counter is reset. The SDD is equipped with an on-board battery to maintain data even

when the main circuit module is completely removed or a complete power outage (including

low battery shutdown) occurs .

2.5.1 "MODE" Switch

The "MODE" switch activates the display and verifies the mode of operation. When

the switch is pressed, the "ELAPSED TIME" LED will light (or "STANDBY EVENTS" LED

depending upon the mode). At the same time, the corresponding information will appear in

the "TIME/EVENTS" window for approximately 10 seconds. The next mode is activated

by pressing the switch again. "ELAPSED TIME" and "STANDBY EVENT" information can

be toggled by briefly pressing the "MODE" switch.

NOTE: To clear either the "ELAPSED TIME" or "STANDBY EVENT" memory, select

the desired mode. Press and hold the "MODE" switch until the LED flashes. Then, press

the MODE switch twice (in rapid succession). A single decimal point will appear in the

display when the memory has been cleared.

2.5.2 "ELAPSED TIME" LED

The "ELAPSED TIME" LED indicates the mode as the "TIME/EVENTS" window

displays the time accumulated during inverter operation. The clock, which displays time to

the nearest 0.1 hours, will continue to accumulate time until the memory is manually

cleared.

2.5.3 "STANDBY EVENTS" LED

The "STANDBY EVENTS" LED indicates the mode as the "TIME/EVENTS" window

displays standby events that have lasted more than 60 seconds in duration. The counter

will continue to register standby events until the memory is manually cleared.

2.5.4 "TIME/EVENTS" Window

The "TIME/EVENTS" window displays "ELAPSED TIME" in 0.1 hr increments, up to

999.9. "STANDBY EVENTS" are displayed in increments of 1, up to 9999.

"MODE" Switch

(Selects TIME or EVENTS mode; clears memory)

"ELAPSED TIME" (green) LED

(Indicates ELAPSED TIME mode)

"STANDBY EVENTS" (green) LED

(Indicates STANDBY EVENTS mode)

"TIME/EVENTS" Window

(Displays TIME and EVENTS information)

(OPTIONAL FEATURE)

STANDBY DATA Display

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 60 61

Comments to this Manuals

No comments

Alpha XM 6015 Series Operations Instructions Page 20

Comments to this Manuals

Related products and manuals for Power supply units Alpha XM 6015 Series