Alpha AIR-658 Instruction Manual

Part No: AIR-658Version 5103 Bauer Drive, Oakland, NJ 07436 • 800-648-7229 • Fax: 800-286-0114www.alpha-tools.comAlpha® PneumaticAir PolisherInstructi

10Lubricating the tool before and during working is not needed. Ex-cessive oil will turn to a tar-like substance inside the tool, causing the vanes to

11 AIR VALVE LEVER The valve lever controls the flow of air through the tool. It has two positions- ON or OFF. Run the tool at the recommende

12Maintenance and Usage Tip:The Silencer is located on the rear of the polisher under the air and water ttings. A clogged Silencer would be indicate

13ALPHA® PNEUMATIC AIR POLISHER SCHEMATIC

14 ALPHA® PNEUMATIC AIR POLISHER PARTS LIST (VERSION 5)DRAWING NO. PART NO. ITEM DESCRIPTION QUANTITY1 658-01 Screw M4x10 22 658-02 Pipe-joint Assembl

15 ALPHA® PNEUMATIC AIR POLISHER PARTS LIST (VERSION 5)DRAWING NO. PART NO. ITEM DESCRIPTION QUANTITY51 658-51 Screw M4x15 452 133236 Compression Wash

16APPENDIX A —OPTIONAL ACCESSORIES SPLASH / SAFETY GUARD For operator comfort and safety, a splash guard is recommended. The guard should remain in p

172. Choose the desired height according to the application to be performed and cut along the grooved cut lines to adjust the height. 3. Install the

18All the accessories can be purchased at a local distributor in your area. For more information concerning Alpha® Air Polisher and factory serv

19PRODUCT REGISTRATION CARDModel No. Serial No.Company Name: ______________________________________________Name: ___________________

2TABLE OF CONTENTSIntroduction ...3About the Symbols ...

Copyright © 2013 Alpha Professional Tools. All rights reserved. 103 Bauer Drive, Oakland, NJ 07436 • 800-648-7229 • Fax: 800-286-0114www.alpha-tools.c

3 INTRODUCTIONThank you for purchasing an Alpha® Air Polisher. This polisher is the workhorse of a complete polishing system. A wide range

4 SAFETY INSTRUCTIONS FOR POWER TOOLS 1. KNOW YOUR POWER TOOL. Read owner’s manual carefully. Learn its applications and limitations as well

512. DON’T OVERREACH. Keep proper footing and balance at all times. 13. DISCONNECT TOOLS WHEN NOT IN USE. Always disconnect tool before servi

6AIR-658 OVERVIEWRubber Splash Guard(Optional Accessory)Reversible Handle10 ft Water Hose10 ft Air HoseAdjustable Air ValveAdjustable Water ValveRubbe

7 ACCESSORIES Water hose (10 ft / 3m) ...1pc Air hose (10 ft / 3m)...1p

8 CONNECTION FITTINGSThe air and water hose ttings on the back of this tool are BSPP (British standard parallel pipe or “G” thread). These ttings h

9 AIR PRESSURE AND VOLUMEThe recommended air pressure for this tool is 87 PSI (6 BARS), however, the range of 85 to 90 psi is acceptable. Any pr