Alpha MED64 MED-A64HE1 Manual

Product ManualMED Heated Connector P/N: MED-CP02HFor the serial# smallerthan 2013CD01034Alow‐n

8Cleaning of contact pinsWipe the contact pins several times while pushing them with a lint-free cloth. (e.g. Lens cloth for glasses).If some contact

9The terminal arrangement of electrodes on the MED probe and the MED Heated ConnectorElectrode OrientationOnce the MED Probe is set in the MED Heated

10WarrantyThis product will be repaired with new or refurbished parts, free of charge, for one (1) year from the date of original purchase in the even

ME

June 1, 2

Information in this document is subject to change without notice. No part of this document may be reproduced or transmitted without the expressed writ

1Table of ContentsMED Heated Connector Components and Functions 2Installation 31. Orientation of the MED Heated Connector 3 2. Con

2MED Heated Connector Components and FunctionsThe MED Heated Connector (MED-CP02H) functions to connect the MED Probe to the MED64 Head Amplifier (64-

3InstallationThe MED Heated Connector is compatible with the ThermoClampTM-1 manufactured by AutoMate Scientific. Please refer to the product manual (

43. Installing the MED probe onto the Heated ConnectorLoosen the lock screws on the connector unit (top unit) and remove it. Place the MED Probe fille

5Fig. 10. (Left) Connection of the MED Heated Connector to the MED Connector Cable. Fig. 11. (Right) Back side of the MED64 Amplifiers. The MED Conn

6Instructions for useSetting temperature• Temperature is set and controlled by the ThermoClampTM-1. Please read the manual before using it with the ME

7Maintenance Replacement of the tubes incorporated into the heater unitReplace the tube regularly according to following procedures.SpecificationTygon