55
5
DOCNUMBER 9500
Document Issue 1.1
February 2010 Page 5–13
RF Concepts, LLC Alpha 9500 Linear Amplifier User Manual
Product Release 1 Operating the Amplifier
7a TURN OFF the amplifier immediately.
7b Ensure that the exhaust chimney is properly positioned over the tube.
7c Power up the amplifier again.
NOTE
•
If the amplifier faults, it usually resets itself after 4 seconds.
— To reset the amplifier manually if it fails to reset itself, push
ON/AMP and then OPR. (You need not turn the amplifier off.)
— To display the last fault, press the FLT button and view the 7-
segment display.
— To display the last 20 faults, open the AR9500 PC application
that allows remote control over a serial interface and select
the correct COM port. Select Tools > Get fault log.
To see a complete list of possible faults, see Chapter 8,
“Diagnosing Faults.”
•
You can optionally control the Alpha 9500 completely from the
Microsoft
®
Windows
®
AR9500 PC application rather than the
front panel. For more information, see Chapter 6, “Operating the
Amplifier from a PC.”
Comments to this Manuals